Mercedes C-Class

W203 since 2000 of release

Repair and car operation



Mercedes-Benz
+ Mercedes-Benz Cars of a class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   - Leaving and external equipment of a body
      General information and security measures at carrying out body works
      Cleaning and leaving
      Repair of insignificant damages of body panels
      Repair of considerable damages of a body
      Windscreen damages as a result of hit of stones
      Replacement of brushes of screen wipers
      Removal and installation of a jet of a stekloomyvatel of a windscreen
      Removal and installation of a jet of back glass
      Removal and installation of the lever of a screen wiper of a windscreen
      Removal and installation of the lever of a back screen wiper
      Removal and catchment basin installation
      Removal and cowl installation
      Removal and installation of facing of a cowl
      Cowl adjustment
      Removal and installation of the lock of a cowl
      Detachment of a cable of a drive from the cowl lock
      Removal and installation of a lattice of a spoiler
      Removal and bumper installation
      Removal and installation of a rear bumper
      Removal and installation of a forward wing
      Removal and installation of a protective level on a wing
      Removal and installation of a protective level on a bumper
      Removal and installation of a protective level on a door
      Removal and installation of a forward loker covered
      Removal and installation of a back part of a loker of a wing
      Removal and installation of a forward door
      Door adjustment
      Removal and installation of forward facing of a door
      Removal and installation of a triangular slip
      Removal and installation of the external handle of a door
      Removal and installation of facing of an external rear-view mirror
      Removal and installation of an external mirror
      Removal and installation of glass of a mirror
      Removal and trunk lid installation
      Removal and installation of facing of a trunk lid
      Removal and installation of a clamp of the lock of a luggage carrier
      Removal and installation of the lock of a door of a back
      Removal and installation of the mechanism of the lock of a door of a back
      Removal and installation of the cylinder of the lock of a luggage carrier and back door
      Removal and installation of a door of a back
      Adjustment of a door of a back
      Removal and installation of facing of a door of a back
      Removal and installation of facing of a door of a back
      Removal and installation of a back spoiler
      Removal and installation of a cap of a cargo compartment
   + salon Equipment
+ Onboard electric equipment






Removal and installation of a forward door

Removal

 PERFORMANCE ORDER

1. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.

 Before a detachment of a cable find out a protective code of a radio receiver if that is available, address to the Section Replacement of the storage battery.

2. Completely lower glass and open a door.
3. Separate by means of a plastic wedge an entrance level of a door from the holder of a clip and remove.
4. Remove the bottom fringing on a rack And.
5. Take out a cover from facing in the bottom of a rack And around feet and turn out a bolt lying under it.
6. Separate by means of a plastic wedge facing in the bottom of a rack And from holders of a clip and remove. Under it there are electric wires of a door.
7. Disunite sockets of electric wires.

8. Take out by means of a plastic wedge a cover for a cable (1) of a rack And and extend wires.

9. Turn out bolts of fastening (2) stoppers of a door.
10. Ask the assistant to take a door. Turn out nuts (3) fastenings of a loop below and above. Remove a door and put it on a soft lining.


Installation

 PERFORMANCE ORDER

1. By means of the assistant establish into place a door and screw nuts of fastening of loops, without tightening them.
2. Close a door and check a gap. If necessary adjust a door, address to appropriate section.
3. Tighten nuts of fastening of loops the moment 8Нм.
4. Fix a door stopper the moment 10Нм.
5. Further installation is carried out in sequence, return to removal.
6. Attach a negative cable (-) to a battery battery room at the switched-off ignition. Establish into place a box of the filter of air of salon. Enter a code of a radio receiver and establish time on hours.