|
1. Open a back door.
|
|
2. Take out a clip from openings on a back cover. |
3. Enter a plastic wedge, for example, HAZET 1965-20 in the gap middle (the shooter on an illustration) between lateral and bottom facings of a frame and disconnect facing elements from connections of clips.
|
|
Facing elements in this place are stuck together among themselves. |
4. Partially separate the bottom facing of a frame (2) from facing of a door of a back (3), having strongly pulled for it, and applying a plastic wedge.
5. Pull a plastic hook from holders of a clip on facing of a door of a back. For this purpose enter a screw-driver into a gap between facing of a door and frame facing. Disconnect a plastic hook in hammer blow on a screw-driver.
|
|
The plastic hook can break thus. |
|
|
6. Undertake a hand between facing of a door of a back and a door and pull strong breakthrough consistently 6 clips (arrows on an illustration). If it is necessary, use a plastic wedge. |
7. Remove facing (1) together with lateral facing of a frame (2).
|
|
The lower part of lateral facing should be taken out from lateral facing at a back window by movement aside from a window. |
|
|
8. Disconnect lateral facing (1) at a back window by means of a plastic wedge from 5 holders of a clip (2). (3) – top facing of a back window. |
|
|
9. Disconnect 3 plastic levels (3) of connections (3) and separate lateral facing of a back window (4) from the top facing of a window (1). |
10. Disconnect the top facing of a back window (1) strong breakthrough from 6 holders of clips (an arrow on an illustration) and remove it. |