Mercedes C-Class

1. Mark with paint the provision of the corresponding forward wheel concerning a nave. It will allow to establish at assembly an otbalansirovanny wheel in its former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a forward part of the car, put it on supports and remove a forward wheel.
2. Lift a forward part of the car and establish on supports.

Operation of lifting and car installation on supports is connected with danger! Therefore before carrying out operation familiarize with Poddomkrachivaniye's Section and Introduction towage to the management.

3. Remove a forward loker, address to appropriate section.

4. Turn out the lock screw (1) between a wing and a bumper. (4) – adjusting screw.

5. Disconnect by means of a screw-driver (2) bracket (3) from a bumper and incline it to the car center.
6. Pull a bracket back and remove from a bumper.
7. Remove the sensor of temperature of external air, address to the Section Removal and installation of the sensor of temperature of external air.
8. Disunite the socket of the left and right fog lights.
9. Disunite the socket of the assistant to a parking if it is established.

10. Turn out 2 screws of fastening (2) on the right and at the left at fog lights.

11. Open a cowl and turn out 2 screws (1) on the right and at the left at headlights.
12. Remove by means of the assistant a bumper from the car.

1. Establish by means of the assistant a bumper into place.
2. If it is necessary, adjust by means of the screw (4) a gap. Value of a gap is given in Specifications.
3. Fix a bumper 4 screws the moment 4Нм.
4. Insert a bracket between a wing and a bumper so that the collar of a bracket entered in directing on a bumper. Screw the lock screw.
5. Establish the sensor of temperature of external air, address to the Section Removal and installation of the sensor of temperature of external air.
6. Join the socket of foggy lamps.
7. Join the socket of the assistant to a parking if it is available.
8. Establish a loker of a wing, address to the Section Removal and installation of a forward loker covered.
9. Establish into place a forward wheel so that the marks put at removal coincided. Previously grease with a thin layer of bearing greasing aligning belt of a disk of a wheel on a nave. Bolts of fastening of a wheel do not grease. Rusty bolts replace. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment 110Нм.
10. Attach a negative cable (-) to a battery battery room at the switched-off ignition. Establish into place a box of the filter of air of salon. Enter a code of a radio receiver and establish time on hours.
11. As soon as possible check adjustment of headlights on HUNDRED and, if necessary, adjust.