|
1. Models with the hook-on device: Unscrew nuts at adjusting fingers.
|
|
2. Take out 2 razzhimny clips (1) and one nut (2) fastenings of a loker of a wing. |
3. Wring out a loker of a wing aside and turn out the screw (3) between a bumper and a wing.
|
|
4. Turn out 4 bottom bolts of fastening from a cross-piece. |
5. Turn out a fastening bolt (the shooter on an illustration) the holder of the exhaust silencer.
6. Disunite the socket of the assistant to a parking if it is available.
7. Open a back cover. Take out a cover in the luggage carrier bottom. Take out a cover over an additional compartment for a spare wheel.
8. Release covers on the right and at the left in facing, lower them and take out.
|
|
9. Pocket at the left: Turn out the screw (1). Turn out 3 screws (2) and take out a box for tools. |
|
|
10. Pocket on the right: Turn out 2 screws (1) and take out a compartment (2). |
|
|
11. Left side: Turn out 1 bolt (1) and 4 nuts (2, 3, 4) fastenings of a rear bumper. (5) – a back lamp, (6) – the block of safety locks.
|
|
The 16-faced head is necessary for an otvorachivaniye of nuts (3) and (4). |
|
12. Right side: Also unscrew a bolt and 4 nuts.
13. By means of the assistant take out back from directing a bumper and a cross-piece and remove them.
14. Turn out 4 top screws from a cross-piece and separate a bumper and a cross-piece. |