Mercedes C-Class

Check gaps in interface of a door of a back to adjacent elements of a body. Values are given in Specifications.

1. Open a back door.

2. Turn out bolts of fastening (1) on the right and left loops.

3. Remove a cap of a cargo compartment, address to appropriate section.
4. Unscrew bolts of fastening of a clamp.
5. Unscrew bolts of fastening of a lateral plastic emphasis. Wring out an emphasis forward.
6. Close a door of a back and adjust a gap. Fix bolts of loops and a clamp the moment 9Нм.
7. Adjust an emphasis so that they adjoined at the closed door. Tighten fastening bolts.
8. Establish into place a cap of a cargo compartment, address to appropriate section.

Check gaps in interface of a door of a back to adjacent elements of a body. Values are given in Specifications.

1. Open a back door.
2. Disconnect by means of a plastic wedge roof facing in a back part of salon and pull back a little. Carefully insert wooden whetstone in height of 65 mm between a roof and facing.
3. Unscrew 2 nuts of fastening of a loop between a roof and facing.
4. Take out a clip and remove internal facing in a luggage carrier.
5. Unscrew bolts of fastening of a clamp.
6. Close a door of a back and adjust a gap. Tighten bolts and fastening nuts on loops the moment 9Нм.
7. Establish internal facing in a luggage carrier and fix roof facing.