Mercedes C-Class

1. Mark with paint the provision of a back wheel concerning a nave. It will allow to establish at assembly an otbalansirovanny wheel in its former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a back part of the car, put it on supports and remove a back wheel.

Operation of lifting and car installation on supports is connected with danger! Therefore before carrying out operation familiarize with Poddomkrachivaniye's Section and Introduction towage to the management.

2. Unscrew plastic nuts and take out razzhimny a clip (arrows on an illustration).

3. Take out a loker of a wing from a wheel arch.

1. Installation is carried out in sequence, return to removal.
2. Establish into place a back wheel so that the marks put at removal coincided. Previously grease with a thin layer of bearing greasing aligning belt of a disk of a wheel on a nave. Bolts of fastening of a wheel do not grease. Rusty bolts replace. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment 110Нм.