1. Open a cowl. 2. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.
3. Turn out саморез at the union for filling of the tank of a stekloomyvatel. 4. Lift and establish a forward part of the car on supports.
|
Operation of lifting and car installation on supports is connected with danger! Therefore before carrying out operation familiarize with Poddomkrachivaniye's Section and Introduction towage to the management. |
5. Remove a forward loker, ahead and above, address to the Section Removal and installation of a forward loker covered.
|
6. Take out water hoses and the tip (1) at electric motors of pumps (2).
|
Electric motors are fixed behind at the tank of a stekloomyvatel (3). |
|
7. Take out the socket of the switch of control of a water level (6). 8. Disconnect and take out the pump electric motor from the holder on the tank of a stekloomyvatel.
|
9. Turn out the screw of fastening and take out a branch pipe of filling with water (4) of the tank (3). (5) - sealing ring. |
10. Turn out 3 screws of fastening (an arrow on an illustration) and take out the tank from an impellent compartment. |