Mercedes C-Class

W203 since 2000 of release

Repair and car operation



Mercedes-Benz
+ Mercedes-Benz Cars of a class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Specifications
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Relay and safety locks
   Replacement of filament lamps of devices of external lighting
   Replacement of filament lamps of devices of internal lighting
   Removal and installation of the sensor of a daylight
   Removal and headlight installation
   Removal and installation of a fog light
   Removal and installation of a rasseivatel of a fog light
   Removal and installation of a back lamp
   Replacement of the battery of a key of an ignition/remote control
   Removal and installation of the electric motor of a cleaner of a windscreen
   Removal and installation of the electric motor of a cleaner of back glass
   Removal and installation of the tank of water and pump electric motor
   Removal and installation of the sensor of a rain
   Removal and installation of a sound signal
   Removal and installation of sensors of a parking
   Removal and installation of the sensor of temperature of external air
   Removal and installation of a control panel
   Removal and installation of the podrulevy switch
   Removal and installation of the switch of a forward plafond on a ceiling
   Removal and installation of group of switches to the left of a control panel
   Removal and installation of the switch of the central console
   Removal and installation of switches in the doorway
   Removal and installation of door switches of internal lighting
   Removal and installation of precautionary indexes of the assistant to a parking
   Removal and lighter installation
   Removal and radio receiver installation
   Removal and loudspeaker installation
   Digital tire of data of CAN
   The uniform lock - general information
   Installation of additional electric and electronic devices
   Appointment and arrangement of electric sockets
   + electric equipment Schemes






Removal and installation of group of switches to the left of a control panel

In group of switches at the left, near a steering wheel, various switches of light, and also the switch of adjustment of an external rear-view mirror are established. The group of switches at failure of any element is replaced in a set.

Removal

 PERFORMANCE ORDER

1. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of a radio receiver if that is available, address to the Section Replacement of the storage battery.

2. Uncover the block of safety locks sideways at the dashboard, address to the Section of the Relay and safety locks.

3. Take out from the dashboard the handle (1) release of the parking brake, turn out 2 screws (2) and press the handle down.

4. Turn out the lock screw (3) groups of switches.

5. Compress 2 lock springs and take out group of switches (2) of the dashboard.

6. Release the connecting tip from a reverse side of group of switches and disconnect it.
7. Disconnect a regulator of range of light from the holder at group of switches and displace aside.


Installation

 PERFORMANCE ORDER

1. Installation is carried out in sequence, return to removal.
2. Attach a weight cable (-) the storage battery at the switched-off ignition. Establish into place a box of the filter of air of salon. If it is necessary, enter a code of a radio receiver and establish time on hours.