Mercedes C-Class

W203 since 2000 of release

Repair and car operation

Removal and installation of the podrulevy switch

Podruleva the switch carries out switching of the following devices: passing beam, driving beam, indexes of turns and screen wiper.

Removal

PERFORMANCE ORDER

1. Establish wheels directly.
2. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of a radio receiver if that is available, address to the Section Replacement of the storage battery.

Surely observe security measures at the address with a safety cushion, address to the Security measure Section at works with a safety cushion.

3. Remove a steering wheel, address to the Section Removal and installation of a steering wheel.

Operation of lifting and car installation on supports is connected with danger! Therefore before carrying out operation familiarize with Poddomkrachivaniye's Section and Introduction towage to the management.

4. Turn out screws of fastening (1) contact spiral at standing directly forward wheels so that it was possible to take out a spiral.

Do not turn on screws completely. Otherwise the contact spiral appears disassembled and it again should be brought together on the average situation (work HUNDRED).

5. Carefully take out a contact spiral from the podrulevy switch. The socket of the podrulevy switch thus automatically undocks.
6. Turn out 3 screws.

7. Open sockets of the podrulevy switch (1) by compression and take out from the podrulevy switch.

Models with the tempostaty

PERFORMANCE ORDER

1. Uncover under the dashboard, address to appropriate section.
2. Disconnect the switch tip темпостата (2) from the ignition switch.

3. Take out podrulevy the switch with the switch темпостата if the last is established, and disconnect the tip from the podrulevy switch.

Installation

PERFORMANCE ORDER

Surely observe security measures at the address with a safety cushion, address to the Security measure Section at works with a safety cushion.

1. Be convinced that wheels of the car stand directly.
2. Join the socket of the podrulevy switch and establish the switch into place.
3. Insert 2 sockets into the switch and fix.
4. If is available темпостат, join the socket of the switch of ignition and establish a cover under the dashboard, address to appropriate section.
5. Fix podrulevy the switch three screws.
6. Establish a contact spiral against the stop on a steering spindle. Fix the socket.

7. Fix 2 sockets. Thus watch that both markings (shooters on an illustration coincided).

8. Establish into place a steering wheel. Thus observe security measures at the address with a safety cushion, address to the Security measure Section at works with a safety cushion.
9. Attach a weight cable (-) the storage battery at the switched-off ignition. Establish into place a box of the filter of air of salon. If it is necessary, enter a code of a radio receiver and establish time on hours.