Mercedes C-Class

W203 since 2000 of release

Repair and car operation


Mercedes-Benz
+ Mercedes-Benz Cars of a class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Specifications
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Relay and safety locks
   Replacement of filament lamps of devices of external lighting
   Replacement of filament lamps of devices of internal lighting
   Removal and installation of the sensor of a daylight
   Removal and headlight installation
   Removal and installation of a fog light
   Removal and installation of a rasseivatel of a fog light
   Removal and installation of a back lamp
   Replacement of the battery of a key of an ignition/remote control
   Removal and installation of the electric motor of a cleaner of a windscreen
   Removal and installation of the electric motor of a cleaner of back glass
   Removal and installation of the tank of water and pump electric motor
   Removal and installation of the sensor of a rain
   Removal and installation of a sound signal
   Removal and installation of sensors of a parking
   Removal and installation of the sensor of temperature of external air
   Removal and installation of a control panel
   Removal and installation of the podrulevy switch
   Removal and installation of the switch of a forward plafond on a ceiling
   Removal and installation of group of switches to the left of a control panel
   Removal and installation of the switch of the central console
   Removal and installation of switches in the doorway
   Removal and installation of door switches of internal lighting
   Removal and installation of precautionary indexes of the assistant to a parking
   Removal and lighter installation
   Removal and radio receiver installation
   Removal and loudspeaker installation
   Digital tire of data of CAN
   The uniform lock - general information
   Installation of additional electric and electronic devices
   Appointment and arrangement of electric sockets
   + electric equipment Schemes





Removal and installation of switches in the doorway

Top group switches/lobby door

In group of switches near the handle of a door the switch of an electric seat and adjustment of a steering wheel are located depending on the equipment.

Removal

 PERFORMANCE ORDER

1. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of a radio receiver if that is available, address to the Section Replacement of the storage battery.

2. Remove facing on a forward door, address to the Section Removal and installation of forward facing of a door.

3. Wring out a screw-driver lock levels (arrows on an illustration) from a reverse side of facing of a door and take out group of switches (1) of door facing.

4. Disunite the socket at group of switches.


Installation

 PERFORMANCE ORDER

1. Installation is carried out in sequence, return to removal.
2. Attach a weight cable (-) the storage battery at the switched-off ignition. Establish into place a box of the filter of air of salon. If it is necessary, enter a code of a radio receiver and establish time on hours.


Bottom group switches/lobby door

In group of switches depending on the equipment switches of a window regulator, the device of protection against children, and also the switch for luggage carrier opening are established.

Removal and installation of the switch of a window regulator on a door of the forward passenger occurs similarly.


Removal

 PERFORMANCE ORDER

1. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of a radio receiver if that is available, address to the Section Replacement of the storage battery.

2. Remove facing on a forward door, address to the Section Removal and installation of forward facing of a door.

3. Shift from a reverse side of facing of a door blocking (1) in the arrow (2) direction. Disconnect group of switches of the holder (3) and take out.

4. Disunite the socket at group of switches.


Installation

 PERFORMANCE ORDER

1. Installation is carried out in sequence, return to removal.
2. Attach a weight cable (-) the storage battery at the switched-off ignition. Establish into place a box of the filter of air of salon. If it is necessary, enter a code of a radio receiver and establish time on hours.


Window regulator switch / back door

Removal

 PERFORMANCE ORDER

1. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of a radio receiver if that is available, address to the Section Replacement of the storage battery.

2. Remove facing on a back door.
3. Disunite the socket at the switch.

4. Disconnect the switch (1) from a reverse side of facing of a door from the holder and take out.


Installation

 PERFORMANCE ORDER

1. Installation is carried out in sequence, return to removal.
2. Attach a weight cable (-) the storage battery at the switched-off ignition. Establish into place a box of the filter of air of salon. If it is necessary, enter a code of a radio receiver and establish time on hours.