Mercedes C-Class

W203 since 2000 of release

Repair and car operation



Mercedes-Benz
+ Mercedes-Benz Cars of a class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Specifications
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Relay and safety locks
   Replacement of filament lamps of devices of external lighting
   Replacement of filament lamps of devices of internal lighting
   Removal and installation of the sensor of a daylight
   Removal and headlight installation
   Removal and installation of a fog light
   Removal and installation of a rasseivatel of a fog light
   Removal and installation of a back lamp
   Replacement of the battery of a key of an ignition/remote control
   Removal and installation of the electric motor of a cleaner of a windscreen
   Removal and installation of the electric motor of a cleaner of back glass
   Removal and installation of the tank of water and pump electric motor
   Removal and installation of the sensor of a rain
   Removal and installation of a sound signal
   Removal and installation of sensors of a parking
   Removal and installation of the sensor of temperature of external air
   Removal and installation of a control panel
   Removal and installation of the podrulevy switch
   Removal and installation of the switch of a forward plafond on a ceiling
   Removal and installation of group of switches to the left of a control panel
   Removal and installation of the switch of the central console
   Removal and installation of switches in the doorway
   Removal and installation of door switches of internal lighting
   Removal and installation of precautionary indexes of the assistant to a parking
   Removal and lighter installation
   Removal and radio receiver installation
   Removal and loudspeaker installation
   Digital tire of data of CAN
   The uniform lock - general information
   Installation of additional electric and electronic devices
   Appointment and arrangement of electric sockets
   + electric equipment Schemes






Removal and installation of a control panel

Removal

 PERFORMANCE ORDER

1. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.

 Before a detachment of a cable find out a protective code of a radio receiver if that is available, address to the Section Replacement of the storage battery.

To keep the data of a control panel written down in electronic memory, before a detachment of the storage battery connect to the car the special auxiliary power supply, according to the instruction of the manufacturer.

2. Release a steering wheel, pull it up to the end back and press down. Electric drive of adjustment of a steering wheel: Establish a similar position.

3. Enter in a shlitsa (an arrow on an illustration) against the stop at the left and on the right on a control panel (2) exhaust hooks (1).

4. Turn hooks on 90 °, press up blocking (3) and release.

The rotation direction on the right shliyets - clockwise, on the left shliyets – counter-clockwise.

5. Extend a control panel by means of hooks from the dashboard.
6. Release the tip from a reverse side of a control panel and disunite the socket. Take out a control panel.

7. HUNDRED apply to this purpose special exhaust hooks 140 589 02 33 00. Hooks can be made also independently of a wire in diameter 2 – 2.5 mm.

and = 1 cm
b= 10 cm
with = about 7 cm
d= 2–2.5 cm

8. Release a cover of a control panel and remove from the case.
9. Take out from the case an electronic payment.


Installation

 PERFORMANCE ORDER

1. Insert an electronic payment into the case of a control panel. Thus watch that the button of return of the counter of a day distance in kilometers had the correct situation.
2. Put a cover on the case and fix on pads.
3. Join the socket of a control panel and fix it.
4. Insert a control panel into the dashboard, evenly press and fix. Thus do not warp a control panel.
5. Establish a steering wheel in normal situation.
6. Attach a weight cable (-) the storage battery at the switched-off ignition. Establish into place a box of the filter of air of salon. If it is necessary, enter a code of a radio receiver and establish time on hours.