Mercedes C-Class

W203 since 2000 of release

Repair and car operation

Mercedes-Benz
+ Mercedes-Benz Cars of a class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
   + ignition and engine management System
   + System of preheat of the diesel engine
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Charge and start systems
      The storage battery - the main data and acquisition of the new battery
      Check and charging of the storage battery
      Replacement of the storage battery
      Storage of the storage battery
      Charging system - general information and security measures
      Check of system of a charging
      Removal and generator installation
      Removal and installation of a regulator of tension. Replacement of brushes
      System of start of the engine - the general information and precautionary measures
      Removal and starter installation
      Removal and installation of the traction relay of a starter
      Check of system of start of the engine
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a regulator of tension. Replacement of brushes

Petrol engines 111, 112

Removal

PERFORMANCE ORDER

1. Remove the generator, address to appropriate section.
2. Unscrew nuts on plugs.

3. Turn out screws (1) and remove from the generator a protective cover (2), having dissolved thus lock levels (3).

Depending on model of the engine generators of various capacity can be established.

4. Turn out screws (4) and take out aside a regulator (5). (6) – weight accession.
5. Replace brushes, for what отпаяйте cables.
6. Check wear of contact rings, if necessary, pierce them and polish (work HUNDRED).

Installation

PERFORMANCE ORDER

1. Insert new brushes (And) and springs (In) in a shchyotkoderzhatel (C) and solder them. The illustration has informative character and cannot correspond to considered model completely.

2. To exclude solder hit at the soldering of new brushes, hold cables flat-nose pliers.

Solder leads to a tverdeniye of ropes that does them not efficient.

3. Establish and fix a tension regulator.
4. After installation of new brushes check ease of their course in shchyotkoderzhatel.
5. Fix on the generator a protective casing.
6. Fix nuts on plugs.
7. Establish the generator, address to appropriate section.