The device, service, repair of Mercedes-Benz C of Class (W-203 c 2000г) - Removal and installation of the traction relay of a starter-//Mercedes Benz - mikbookmarket.ru

Mercedes C-Class

W203 since 2000 of release

Repair and car operation



Mercedes-Benz
+ Mercedes-Benz Cars of a class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
   + ignition and engine management System
   + System of preheat of the diesel engine
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Charge and start systems
      The storage battery - the main data and acquisition of the new battery
      Check and charging of the storage battery
      Replacement of the storage battery
      Storage of the storage battery
      Charging system - general information and security measures
      Check of system of a charging
      Removal and generator installation
      Removal and installation of a regulator of tension. Replacement of brushes
      System of start of the engine - the general information and precautionary measures
      Removal and starter installation
      Removal and installation of the traction relay of a starter
      Check of system of start of the engine
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment







Removal and installation of the traction relay of a starter

Removal

 PERFORMANCE ORDER

1. Remove a starter, address to appropriate section.
2. Clamp a starter in a clamp. Tightening sponges for protection wrap a rag.

3. Unscrew a nut and disconnect a cable from the plug (1) on the traction relay.

4. Unscrew nuts (1) and take out the traction relay from the starter block.

Installation

 PERFORMANCE ORDER

1. Grease an interfaced surface of the block of a starter with hermetic.
2. Connect the traction relay to the block of a starter and fix.
3. Fix a cable to the plug of the traction relay.
4. Check a starter before installation in the disconnected condition.
5. Establish a starter, address to appropriate section.