The device, service, repair of Mercedes-Benz C of Class (W-203 c 2000г) - Installation of the piston of the first cylinder in situation VMT-//Mercedes Benz - mikbookmarket.ru

Mercedes C-Class

W203 since 2000 of release

Repair and car operation



Mercedes-Benz
+ Mercedes-Benz Cars of a class C (W-203)
+ Operation manual
+ Routine maintenance
- Engine
   Compression check in engine cylinders
   Engine check by means of the vacuum gage
   Removal and installation of a cover of an impellent compartment from the bottom
   + 4-cylinder petrol engines
   + 6-cylinder petrol engines
   - Diesel engines
      Removal and installation of the top cover of the engine
      Installation of the piston of the first cylinder in situation VMT
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a head of cylinders
      Removal and installation of a forward cover
      Removal and installation of the top directing chain
      Replacement of chains of a drive of GRM and installation of phases of a gazoraspredeleniye
      Removal and installation of camshafts
      Removal and installation of an intermediate asterisk
      Removal and installation of a natyazhitel of a chain
      Removal and installation of a maple belt
   + System of greasing of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment







Installation of the piston of the first cylinder in situation VMT

Removal

 PERFORMANCE ORDER

1. Uncover heads of cylinders, address to the Section Removal and installation of a cover of a head of cylinders.

2. Establish the piston of the first cylinder in situation VMT. For this purpose switch a transmission in the provision of a neutral course and turn a cranked shaft a face key for the central bolt of fastening of a pulley of a cranked shaft in the direction of rotation of the engine, i.e. clockwise. Rotate a cranked shaft while a label "FROM" on a pulley and the index will not coincide.

Do not rotate the engine crankshaft in the opposite direction. Do not rotate the engine crankshaft for a bolt of fastening of an asterisk of a camshaft.

3. In this situation the drift (1) (a lock pin) should be entered through the first cover of bearings of a camshaft into an opening in an asterisk (2) camshafts of inlet valves. Otherwise turn a cranked shaft on a complete revolution and again insert a drift.


Installation

 PERFORMANCE ORDER

1. Take out a lock pin.
2. Establish a cover of a head of cylinders, address to appropriate section.