Mercedes C-Class

1. Disconnect a negative cable (-) the storage battery at the switched-off ignition. Previously it is necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of a radio receiver if that is available, address to the Section Replacement of the storage battery.

2. By means of a plastic wedge or a flat knife uncover over a ventilating nozzle and take out clips (arrows on an illustration) from holders. (1) – forward persistent pads.

3. Depending on the equipment disunite the socket of the block of the help at a parking or a loudspeaker.

4. Turn out 4 screws (arrows on an illustration) and take out a ventilating nozzle (1) of the dashboard.

1. Installation is carried out in sequence, return to removal.
2. Attach a weight cable (-) the storage battery at the switched-off ignition. Establish into place a box of the filter of air of salon. If it is necessary, enter a code of a radio receiver and establish time on hours.

3. Disconnect a screw-driver the top lock hooks at both deflectors and incline deflectors up to the end down.

4. Enter a screw-driver (2) through a crack and insert into a groove of a lock uvula (1).

5. Press a uvula (1) down and disconnect the first deflector.
6. Similarly remove the second deflectors and take out both deflectors from the ventilating channel.

1. Insert ventilating deflectors into the canal so that the directing pin entered into a reception part in the deflector center.
2. Fix deflectors.
3. Release deflectors and incline upward. Enter screws through a groove and screw.

1. Uncover the block of safety locks sideways at the dashboard, address to the Section of the Relay and safety locks.
2. Remove group of switches to the left of the control panel, address to the Section Removal and installation of group of switches to the left of a control panel.

3. Turn out 2 screws (1) fastening of the ventilating deflector.

4. Turn out screws and squeeze out the lower part of the dashboard (2) as it is described in the Section Removal and installation of the lower part of the dashboard.

5. Press a screw-driver to the left lock hooks and incline the deflector up to the end down. Enter a screw-driver (2) through a groove, press lock pads (1) down and take out the deflector from the ventilating channel.

1. Insert the deflector into the ventilating canal, fix and fix screws.
2. Further installation is carried out in sequence, return to removal.

1. Turn out screws and lower down a ware box as it is described in the Section Removal and installation of a ware box.

Further dismantling corresponds to the same operation for the lateral left ventilating deflector.

2. Turn out screws of fastening of the deflector.
3. Press a screw-driver to the right lock hooks and incline the deflector up to the end down. Enter a screw-driver (2) through a groove, press lock pads (1) down and take out the deflector from the ventilating channel.

1. Insert the deflector into the canal, fix and fix screws.
2. Further installation is carried out in sequence, return to removal.