Mercedes C-Class

W203 since 2000 of release

Repair and car operation

+ Mercedes-Benz Cars of a class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Suspension bracket of forward wheels
   - Suspension bracket of back wheels
      Removal and installation of the back shock-absorber
      Removal and installation of a back spring
   + Corners of installation of wheels of the car
   + Steering and safety cushions
+ Body
+ Onboard electric equipment

Suspension bracket of back wheels

General information

Suspension bracket of back wheels

1 — the Drive of back wheels
2 — the Main transfer
3 — the Screw spring
4 — the Shock-absorber
5 — the Beam of a back suspension bracket
6 — Torsionny the stabilizer of cross-section stability
7 — the Lever of a back suspension bracket

The suspension bracket of back wheels is executed in the form of spatial multilever system and consists of a beam to which bolts via rezinometallichesky bearings suspension bracket levers fasten. Before a beam there is a stabilizer of cross-section stability (except the C180 model), a reducing inclination of a body at turn, and also interfering internal software lifting to the relation to turn of a back wheel.

For amortization of a body two screw springs serve. Gas-filled shock-absorbers are located near springs. Such design occupies insignificant volume in a luggage carrier or a cargo compartment.