Mercedes C-Class

1. Depending on model cast away a back seat forward or remove it, address to appropriate section.
2. Remove a rug from a floor under a back seat.

The rug is extended at the seat cast away forward under a back and back facings of a threshold of a door.

3. Disconnect a cover of the adjusting device.
4. Completely release the parking brake and weaken a cable tension, address to the Section of Check of brake system. Adjustment of the parking brake.

5. Disconnect cables (1) and (2) from the adjusting device.

6. Compress plastic levels (arrows on an illustration) on the end of a cable and disconnect cables in places of pass them in the body bottom.

7. Disconnect a forward cable from a pedal of the parking brake (1). Compress plastic levels on the end of a cable and extend a cable from the holder (2) on a pedal.

8. Attach an auxiliary rope by the end of a forward cable.
9. Mark with paint the provision of back wheels concerning naves. It will allow to establish at assembly otbalansirovanny wheels in their former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a back part of the car, put it on supports and remove back wheels.

Operation of lifting and car installation on supports is connected with danger! Therefore before carrying out operation familiarize with Poddomkrachivaniye's Section and Introduction towage to the management.

10. Remove a support of a back brake, address to appropriate section.
11. Remove a brake disk of a back brake, address to appropriate section.
12. Remove brake shoes of the parking brake, address to appropriate section
13. Disconnect a back cable from the razzhimny lock of a parking drum-type brake.
14. Unscrew bolts and uncover an impellent compartment, address to the Section Removal and installation of a cover of an impellent compartment from the bottom.
15. Extend cables from passes to the bottom, disconnect from holders and remove.

1. Attach an auxiliary rope by the end of a forward cable. Stretch a cable for the rope end through holders and passes to the bottom.
2. Stretch a back cable through the holder and pass to the bottom.
3. Further installation is carried out in sequence, return to removal.
4. Establish into place back wheels so that the marks put at removal coincided. Previously grease with a thin layer of bearing greasing aligning belt of a disk of a wheel on a nave. Bolts of fastening of wheels do not grease. Rusty bolts replace. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment 110Нм.
5. Adjust the parking brake, address to the Section of Check of brake system. Adjustment of the parking brake.